This website uses cookies. By using this site, you consent to the use of cookies. For more information, please take a look at our Privacy Policy.

Images are for reference only,

See Technical Specifications

LAN9420I-NU +BOM

Single Chip Ethernet Controller supporting 10Mbps/100Mbps, operates at 3.3V, housed in a 128-Pin VTQFP package."

Manufacturer:

Microchip
Mfr.Part #:

LAN9420I-NU
Datasheet:

LAN9420I-NU Datasheet (PDF)
Comments:

10Base-T/100Base-TX Ethernet Controller with PCI interface
Ethernet Bandwidth:

10/100Mbps
TX/RX RAM Buffer(Bytes):

N/A
Interrupt Pin:

1
EDA/CAD Models:

Request Free CAD Models for LAN9420I-NU

Email: [email protected]

Skype: live:.cid.ab6b29428937b76

Tel: +852 95804164

LAN9420I-NU General Description

One of the key advantages of the LAN9420/LAN9420i controller is its descriptor-based scatter-gather DMA, which enables zero-copy drivers for increased throughput and reduced Host load. Additionally, the integrated IRQ deassertion timer allows for precise control over IRQ deassertion time, further optimizing system performance. Support for automatic 32-bit CRC generation/checking, payload padding, and 2K jumbo packets enhances data integrity and transmission efficiency

Key Features

Optimized for embedded applications with 32-bit RISC CPUs
Integrated descriptor based scatter-gather DMA and IRQ deassertion timer effectively increase network throughput and reduce CPU loading
Integrated Ethernet MAC with full-duplex support
Integrated 10/100 Ethernet PHY with HP Auto-MDIX Support
32-bit, 33MHz, PCI 3.0 compliant interface
Reduced power operating modes with PCI Power Management Specification 1.1 compliance
Supports multiple audio & video streams over Ethernet
Cable, satellite, and IP set-top boxes
Digital televisions
Digital video recorders
Home gateways
Digital media clients/servers
Industrial automation systems
Industrial/single board PC
Kiosk/POS enterprise equipment
Fully compliant with IEEE 802.3/802.3u
Integrated Ethernet MAC and PHY
10BASE-T and 100BASE-TX support
Full- and Half-duplex support
Full-duplex flow control
Preamble generation and removal
Automatic 32-bit CRC generation and checking
Automatic payload padding and pad removal
Loop-back modes
One 48-bit perfect address
64 hash-filtered multicast addresses
Pass all multicast
Promiscuous mode
Inverse filtering
Pass all incoming with status report
Wakeup packet support
Auto-negotiation
Automatic polarity detection and correction
Supports HP Auto-MDIX
Supports energy-detect power down
Support for 3 status LEDs
Receive and transmit TCP checksum offload
PCI Local Bus Specification Revision 3.0 compliant
32-bit/33-MHz PCI bus
Descriptor based scatter-gather DMA enables zero-copy drivers
Supports PCI Bus Power Management Interface Specification, Revision 1.1
Supports optional wake from D3cold (via configuration strap option when Vaux is available)
Wake on LAN
Wake on link status change (energy detect)
Magic packet wakeup
3 programmable GPIO pins
2 GPO pins
Serial interface provided for EEPROM
Used to store PCI and MAC address configuration values
Big/Little/Mixed endian support for registers, descriptors, and buffers
IRQ deassertion timer
General purpose timer
Integrated 1.8V regulator
Available in 128-pin VTQFP RoHS Compliant package
Available in commercial & industrial temperature ranges

Specifications

Comments	10Base-T/100Base-TX Ethernet Controller with PCI interface	Ethernet Bandwidth	10/100Mbps
TX/RX RAM Buffer(Bytes)	N/A	Interrupt Pin	1
LEDs	3	Op. Voltage (V)	0
# Ethernet Ports	1	Temp Range Min	-40
Temp Range Max	85	Max Speed	33Mhz
Mixed Endian	Yes	Checksum Offload	Yes
# of Ether Ports	0	Fiber Support	No
Interface	32 bit PCI 3.0	Supply voltage (V)	0
Vdd I/O (V)	3.3	LinkMD Cable Diag	No
ESD Rating (KV)	0	WOL	No
Largets Pkt-Size Bytes	0	# of VLAN	0